Ultrasonic Spot Welding Machine For Front Bumper

Ultrasonic Spot Welding Machine welds three aspects of safe use of car front bumper: test welding before formal welding, maintenance of the machine, and operation during welding.

1. Test welding before formal welding

Test welding operation can effectively find the problem of spot welding machine, find potential safety hazards and eliminate them in time, so how to carry out test welding? The steps are as follows:

(1) Adjust the current, the specific value depends on the situation;

(2) When welding, try to start from the short circuit to the appropriate position;

(3) It is recommended to choose low pressure and production time at the beginning of the test welding, which is safer;

(4) In the welding test welding process, adjust the current size, welding time and pressure size at any time according to the situation of the test welding plate until it is appropriate.

2. Ultrasonic Plastic Spot Welding Machine maintenance

Without the maintenance of the Plastic Spot Welding Machine, no machine can be used safely, so how to maintain the spot welding machine?

(1) In order to ensure the drying of the machine, especially the air compressor and filter, because the water and small particles in the air are often compressed and filtered, the water should be checked and cleaned regularly.

(2) When entering the air, some fog oil can be added to strengthen the lubrication of the equipment and reduce wear.

(3) Once the parameters are set, they shall not be changed arbitrarily during use.

(4) Keep the machine clean.

3. During the welding process, the operation should follow the safety operation procedures, and special attention should be paid not to put the hand between the two electrodes.

parameter

Video